Hi Donny,
I have maintained WM2 view as below:
for storage type full - control quantity = 70 cases & rounding quantity = 70 cases
for storage type case pick - control quantity = 69 cases.
How do i make the transfer order creation(LT03) to go into multiple loops of full pallet?
I have observed that when my order quantity is 80 cases:
Scenario 1:When i go into foreground mode of TO creation and modify the quantity on the screen to 70 then it will pick up one pallet from full and on the second iteration when it only has 10 cases to pick it is picking out of case pick storage type.
Scenario 2: When i go into back ground mode of TO creation it is trying to assign 80 cases at once in which case it is going into full storage type and picking up two full pallets.
So my question is what additional config do i need to make for the TO creation to look at one pallet at a time and decide which storage type should it look for stock?
Thanks,
Harish